Follow the steps for usage
1. place the correct batteries in the detector in the receiver units
2. Make sure that the batteries have been put in the proper positions.
3. Mount the detecet properly by the front door,window frame,driveway.walkpath,backyard or anywhete you need.
4. then switch on the receiver and adjust the volume to either hi or lo position.
5. Now the remote detective system is opetrating with the infrared detect technology
6. Plance the receiver in an easy to reach place.
7. When the detecet senses motion,the receiver will make an audible souned the LED light will flash.
8. Please wait for 30seconds after switching on detective receiver to activate.
9. Pleasse install both units 3 feet above grornd level for optimal performance .
Useful tips
1. Do not place the detectou in areas where the wind will move it .Also try to keep the detective in aclear path to the receiver,sothat you can get optimal petformance.
Care maintenance portion
1. Important:jplease keep the detector receiver in sheltered places to avoid contact of both units from water and direct sunlight/
2. When the LED indicator does not go on the battery power is elther low or dead, At that time you should change the batteries.
3. Clean the detective regularly with a damp cloth to avoid blockage of sensor by dirtor any small particles.
4. Try to keep it in areas where it will not get wet .In additiong ,during heavy storms snowfalls,it is recommended that unit should be moved indoor or in a safe place .
5. Never attemptto take apart the units.
6. When the unit is not in use ,take out all batteries,clean both units and store the units in dry,cool place
7. This device is not a toy and should keep out of reach from
Power
Transmitter:6F-22 9V batter one
Receiver: AA battery two.